Langbahn Team – Weltmeisterschaft

Whipstaff

An animated schematic of the basic workings of a whipstaff on a 15th or 16th century sailing vessel. Shown are the whipstaff, the rowle, the tiller, the rudderstock, and the helmsman.

A whipstaff is a steering device that was used on European sailing ships from the 14th to the 18th century. Its development preceded the invention of the more complex ship's wheel and followed the simple use of a tiller to control the steering of a ship underway.[1]

In a typical arrangement, an iron gooseneck was fitted at the fore end of the tiller. Then, a metal ring was fitted over this and secured with a pin. The ring was attached to a long, thin pole (the whipstaff proper) and this pole connected the tiller to the helmsman one or more decks above it through a pivot point, roll, or rowle, described as "that round piece of wood or iron wherein the whip doth go and is made turn about that it may carry over the whip from side to side with more ease."[2]: p.173  The helmsman himself still usually did not stand on the topmost deck, but rather viewed what lay ahead of the ship through a small port or hatchway in the deck above him called a companion. To move the ship to port, the forward-facing helmsman pulled the top of the staff to his left and pushed the pole down and to the right; to move it to starboard, he pulled the top to his right and pushed the pole down and to the left. In this fashion, the tiller might get as much as 20° of turn[3] though angles of between 5° and 10° seem more likely.[4] The tiller rested on a very strong horizontal wooden bar called the tiller sweep, which was sheathed in metal and coated with soap and grease to minimize the drag of the tiller as it rode across it.

Part of the whipstaff of Vasa, built in the late 1620s

This arrangement, however, meant that the helmsman still had very limited range of control of the tiller's movement (no more than 15° to either side[2]: p.174 ) and he had to steer either with extremely limited views of the sails or sometimes dependent entirely upon the conn for direction. Emphasis had to be placed on the use of sails to control the ship's course, and this was imprecise and depended on the vicissitudes of the wind. Where extreme movement of the rudder was necessary, the use of relieving tackle had to be implemented.

References

  1. ^ Anderson, Romola; Anderson, R.C. (2003). A Short History of the Sailing Ship. Courier Dover. p. 156. ISBN 9780486429885.
  2. ^ a b Harland, John H.; Myers, Mark (1984). Seamanship in the age of sail. Naval Institute. ISBN 9780870219559.
  3. ^ Boudriot, Jean (1980). "The whipstaff". Nautical Research Journal. 26. Washington: Nautical Research Guild: 149–154.
  4. ^ Lavery, Brian (1987). Arming and Fitting of English Ships of War, 1600-1815. Naval Institute. p. 15. ISBN 9780870210099.
Quelle: http://en.wikipedia.org/wiki/Whipstaff