Eisspeedway

Swanson Coupe

Swanson Coupe Model W-15
Swanson Coupe
Role Light aircraft
National origin United States
Manufacturer Swanson Aircraft Company Inc.
Designer Swen Swanson
Introduction 1931
Status Production completed

The Swanson Coupe Model W-15 was a high-wing, cantilever-type monoplane produced in 1931 by Swedish aircraft designer and manufacturer Swen Swanson. Its design was considered innovative and the aircraft was viewed as part of a trend of producing safe and economical airplanes, which would appeal especially to automobile drivers. The Swanson Coupe was also designed to function as trainer aircraft.

Design and development

Swanson's design of the Kari-Keen Coupe monoplane incorporated his trademark seating design of two people in side-by-side configuration which was unusual at the time.[1] Following the first version of the Kari Keen Coupe, Swanson designed the Kari-Keen 90, an improved version.[2] But the Kari-Keen factory fell victim to the Great Depression and by early 1930 it closed its doors. Swanson did not wait for long and left Kari-Keen to devote his time to the design of his Swanson Coupe W-15.[2]

The cockpit of W-15

In 1931, after he left Kari-Keen, Swanson established the Swanson Aircraft Co. Inc. with headquarters at Hopewell, Virginia,[3][4] and built the Swanson Coupe W-15 whose design incorporated new breakthroughs such as a new type of patented wing mounting structure which enabled unobstructed view from the cockpit to both pilot and passenger even from above their heads. The new wing mounting technique also increased the peripheral field of view of the cabin. This was accomplished by eliminating an extra wing span which used to enter the cabin area and obstruct the ceiling of the cockpit thus limiting the overhead field of vision.[2][5][6][7] The Swanson Coupe Model W-15 has been described as "beautiful",[2] and its cantilever wing design has been called "ingenious".[6] The plane was certified by the United States Department of Commerce and was powered by the Warner Scarab engine,[6][8][9] which produced 85 h.p. at 1950 rpm.[8]

The Kari-Keen Coupe and the Swanson Coupe featured the characteristic Swanson cantilever wing design.[10] The Swanson planes also shared a similar seating configuration; the two-passengers were seated beside each other.[11] Model W-15 featured detachable passenger-side controls which could be mounted or removed depending on whether a student pilot was present. This design feature made the plane suitable for use in flight schools. The cabin windshield was made using safety glass and the door window panes were retractable. The plane had two variants: Standard and Deluxe. Both variants had dual flight controls, low pressure tires and mohair interior. Both models featured dual engine throttle controls: the main throttle control and a secondary throttle control button installed on the brake lever.[8] The Deluxe came with an electric starter and more elaborate instrumentation. The prices were $4,450 for the Standard model and $4,985 for the Deluxe.[6]

Impact

Swanson did not have any commercial success with his Swanson Coupe.[2] He subsequently decided to dissolve his aircraft company and went to the midwest to join the aircraft company of his friend Ole Fahlin.[2] The Swanson Coupe became the basis of the first airplane produced jointly by them, the Fahlin SF-1.[12] The Swanson Coupe was mentioned in a 1931 article of The Tuscaloosa News as an example of a closed-cabin, safe and economical airplane which was intended for use by "average men" who also drive cars.[13]

Specifications (W-15)

Data from Flying Magazine. May 1931[6]

General characteristics

  • Crew: one
  • Capacity: one passenger
  • Length: 25 ft 0 in (7.62 m)
  • Wingspan: 34 ft 4 in (10.46 m)
  • Height: 7 ft 7 in (2.31 m)
  • Empty weight: 1,400 lb (635 kg)
  • Gross weight: 2,050 lb (930 kg)
  • Fuel capacity: 40 U.S. gallons (150 L; 33 imp gal)
  • Powerplant: 1 × Warner Scarab , 110 hp (82 kW)

Performance

  • Maximum speed: 125 mph (201 km/h, 109 kn)
  • Cruise speed: 90 mph (140 km/h, 78 kn)
  • Range: 625 mi (1,006 km, 543 nmi)
  • Service ceiling: 16,000 ft (4,900 m)
  • Rate of climb: 700 ft/min (3.6 m/s)

References

  1. ^ The AOPA Pilot. Aircraft Owners and Pilots Association. 1974. p. 68. Swanson's new airplane was the Kari- Keen Coupe, a little side-by-side, two- seater monoplane turned out at a time when such designs were rare. Further, it was a fully cantilevered monoplane with a tapered wood-frame wing and steel-tube ...
  2. ^ a b c d e f U.S. Civil Aircraft. Aero Publishers. 1967. p. 112. ari-Keen" 90 was slight improvement over earlier Swanson design. Fig. 124. Neatly cowled in-line engines of "Osprey" were innovation. of his many accomplishments. Avidly interested in aeronautics, Swanson designed his first airplane in ...[...] Fretting over the inactivity, Swanson left Kari-Keen and began developing the beautiful Swanson "Coupe" model W-15. [...] Failing to achieve any success with his new "Coupe" model W-15, Swanson returned to the mid-west to design two more outstanding airplanes (the Swanson- Fahlin "Coupe" and the "Plymacoupe") before he succumbed to a very bad case of ...
  3. ^ Aero Digest. Vol. 18–19. Aeronautical Digest Publishing Corporation. 1931. p. 64. THE Swanson Aircraft Company, Inc., of Hopewell, Virginia, is now producing its cantilever monoplane known as the Swanson Coupe, Model W-15, recently approved by the Department of Commerce, and powered by the Warner Scarab ...
  4. ^ Welman Austin Shrader; Eaton Manufacturing Company (1953). Fifty years of flight: a chronicle of the aviation industry in America, 1903-1953. Eaton Manufacturing Co. p. 49. Swanson Aircraft Co., Inc., is incorporated at Hopewell, Va., by Swen S. Swanson to manufacture the Swanson coupe.
  5. ^ Western Aerospace. Western Aviation Magazine. January 1931. p. 84. visibility that gives perfect forward and side vision, and for the first time, allows a full overhead vision — all for both pilot and passenger. This visibility comes from the patented wing truss, ...
  6. ^ a b c d e "Flying Magazine: The Swanson Coupe Has Ingenious Cantilever Wing". Flying: 25. May 1931. ISSN 0015-4806.
  7. ^ Flying. Vol. 38. Ziff-Davis Publishing Company. 1946. p. 88.
  8. ^ a b c Airway Age. 1931. pp. 489–490. New Swanson Coupe The Swanson Coupe THE Swanson Aircraft Company Inc., of Hopewell, Va., has produced the Swanson Coupe, a single engine, cabin monoplane, powered with a Warner Scarab engine, developing 85 hp. at 1950 [...] Dual controls are furnished with both models. By means of an auxiliary push button throttle located on the brake handle, the pilot is able to control the speed of the engine without resorting to the main throttle. Wings Span Chord at root at tip ...
  9. ^ Aero Digest. Vol. 32–33. Aeronautical Digest Publishing Corporation. 1938. p. 152. WARNER POWERED Swanson Coupe: 2-place, side by side cabin; cruises 100
  10. ^ The AOPA Pilot: Voice of General Aviation. Aircraft Owners and Pilots Association. 1980. p. 100. The Kari-Keen Coupe, the Sioux Coupe and finally the Swanson Coupe were all basically the same cantilever-wing cabin ... Swanson teamed up with an old friend, propeller-maker Ole Fahlin, to upgrade the design, which Fahlin produced as ...
  11. ^ Sport Aviation. Vol. 39. Experimental Aircraft Association. 1990. p. 223. A small airplane by standards of the day, it had an upper wing span of 25 ft. ... Swanson would go on to design the Kari-Keen/Sioux Coupe, his own Swan- son Coupe and, with Ole Fahlin, the Plymacoupe ... all 2-place, side-by- side, high wing ...
  12. ^ "W-15 Coupe 1931 (ATC 2-312)". Design carried into Swanson-Fahlin SF-1
  13. ^ Israel Klein, Science Editor, NEA Service (July 15, 1931). "Smaller Planes Designed to Use By Average Man (Aviation Engineers Produce Planes To Catch Eye Of Man Who Drives Car)". The Tuscaloosa News. {{cite news}}: |author= has generic name (help)CS1 maint: multiple names: authors list (link)
Quelle: https://en.wikipedia.org/wiki/Swanson_Coupe